Tabla de contenido
ADJUST THE GUARD (FIG. 4)
WARNING:
battery pack from the cordless angle grinder
when assembling parts, making adjust
ments, or changing application tools could
result in accidental starting and cause seri
ous injury.
1. Remove the battery pack from the
angle grinder
2. Press the guard-adjusting lever, and hold
it to loosen the guard.
3. Rotate the guard to the desired position
and make sure that the lever lines up with
notches on the guard.
4. Release the guard-adjusting lever to lock the
guard; verify that the lever secures the guard.
WARNING:
when grinding with a grinding wheel. It has
been designed for use only with the guard
attached. Attempting to use the grinder
with the guard removed will result in loose
particles being thrown against the opera
tor and possibly serious personal injury.
WARNING:
grinding wheels. Make sure that the guard-
adjusting lever secures the guard before
operation. Keep the guard between you
and wheel. Do not direct the guard open
ing towards your body.
FIG. 4
Notch on the
guard
OPERATION
Failure to remove the
ALWAYS use the guard
Only use the guard with
Guard-adjusting
lever
MOUNTING THE WHEEL (FIG. 5-6)
WARNING:
wheels for which the maximum safe operat -
-
ing speed is rated at or above 11000 RPM.
Use only Type 27 wheels with the thickness
-
of 1/4" (6 mm), such as the one provided with
this product. Never attach a Type 1 straight
or cut-off wheel to this angle grinder. This
product is only designed for grinding. Use
for any other purpose is not recommended
and creates a hazard, which will result in se -
rious injury.
WARNING:
battery pack from the cordless angle
grinder when assembling parts, making
adjustments, or changing application tools
could result in accidental starting and
cause serious injury.
FIG. 5
-
Spindle-lock
button
-
1. Remove the battery pack from the
angle grinder.
2. Make sure that the guard is securely in
place. Depress and hold the spindle-lock
button. Loosen the outer flange with the
supplied wrench while holding the spindle-
lock button down (FIG. 5).
3. Place the inner flange on the spindle;
make sure that the flange is positioned so
that the shape of the opening in the flange
corresponds with the shape at the base of
the spindle.
Only
use
grinding
Failure to remove the
11
11
Tabla de contenido
