Tabla de contenido
SLIDING DESK MOUNT
D - For installation with minimal clamp space:
Skip to step 3, if the Clamp Mount is not attached.
1
Lift and rotate the Base Cover (H) to expose the
three Base Screws (J) one at a time.
2
Using the 5 mm hex key (C), loosen the three
Base Screws (J) to remove Clamp Mount (K).
3
Loosely attach Sliding Clamp (L) to the Base Plate
(M) with the Base Screws. Do not fully tighten
the Base Screws until step 5.
4
Slide the Clamp all the way against the back edge
of the work surface.
5
Finish tightening the three Base Screws.
BOLT-THROUGH MOUNT
E - For installation on a work surface with no space
for a clamp system:
Skip to step 3, if the Clamp Mount is not attached.
1
See steps D – 1, 2 to remove Clamp Mount.
2
Remove the Stem Bolt (N) using the 10 mm hex key
(P)
3
Pass the Bolt-Through Adapter (R) through the base
and
screw into the Stem. Use the 16 mm wrench (S) to
tighten the adapter.
4
Drill a hole (1/2" – 4") through the work surface in
the desired location.**
5
Pass the Bolt (V) through Bolt-Through Plate (U) and
the Hole (T) in the work surface and screw into the
Bolt-Through Adapter in base. Tighten using the 10
mm hex key.
** The Bolt-Through Mount will accommodate holes
and grommets up to 4" (102 mm) in diameter. Holes 2"
or larger will allow cables to be routed through before
installation of the mount.
4
①
H
③
M
⑤
P
N
⑦
T
②
④
L
⑥
R
⑧
J
K
S
U
V
Tabla de contenido
