Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

SECURITY CARTS
TOOLS NEEDED
Rubber Mallet
7/16" Wrench
Shelf x 4
NOTE: Shelf supports are included
in shelf box.
Figure 1
Figure 2
Shelf Support
PAGE 1 OF 12
1-800-295-5510
uline.com
3/8" Wrench
Phillips Head
Screwdriver
SHELVING PARTS
Shelf Support x 16 Sets
Caster x 4
INSTALLATION OF CASTERS
1.
Make sure post is positioned as shown. (See Figure 1)
2. Engage the wheel brakes to keep casters from rolling during
assembly. Use a rubber mallet to tap caster stems into posts.
(See Figure 1)
SHELVING ASSEMBLY
1.
Start with the lowest shelf. Snap the interlocking pieces of a shelf
support (wide end down) around the post at the lowest groove where
shelf is to be located. (See Figure 2)
NOTE: Two ridges are on the inside of each shelf support. The
bottom shelf support ridge should be aligned with the lowest
groove on the post.
2. Slide the shelf support up or down until it snaps into the groove. Add
shelf supports to the same place on the remaining posts.
Para Español, vea páginas 5-8.
Pour le français, consulter les pages 9-12.
Metal Insert
Post x 4
Self-Leveling Foot x 4
NOTE: Self-leveling feet are included
in post box. See Page 3 for installation.
0321 IH-2083
loading

Resumen de contenidos para Uline H-2083

  • Página 5 800-295-5510 uline.mx CARRITOS DE SEGURIDAD HERRAMIENTAS NECESARIAS Mazo de Llave de 7/16" Llave de 3/8" Desarmador Caucho de Cruz PARTES DE ESTANTERÍA Inserto de Metal 4 Repisas 16 Sets de Soportes 4 Ruedas 4 Postes 4 Patas Autoniveladoras para Repisas NOTA: Los soportes para repisas están...
  • Página 6: Continuación De Ensamble De Estantería

    CONTINUACIÓN DE ENSAMBLE DE ESTANTERÍA 3. Deslice los postes a través de la parte inferior de la repisa hasta que la misma se deslice firmemente sobre los soportes. (Vea Diagrama 3) Diagrama 3 4. Coloque la unidad en posición vertical. Golpee ligeramente la repisa para asegurarla.
  • Página 7 ENSAMBLE DE LOS PANELES INSTALACIÓN DE LAS PATAS AUTONIVELADORAS Tapa Superior 1. Retire las tapas de plástico superiores de los cuatro postes. (Vea Diagrama 6) Diagrama 6 2. Retire los protectores para piso y pernos de nivelación de los insertos Diagrama 7 Diagrama 8 de metal de las patas autoniveladoras localizadas en las cajas de los...
  • Página 8: Continuación Del Ensamble De Los Paneles

    4. Levante el pasador y cierre la puerta frontal derecha. Baje el pasador Diagrama 17 Diagrama 18 a su lugar para asegurar la puerta. (Vea Diagrama 17) 5. Puede colocar un candado (no incluido) en el pasador como se muestra. (Vea Diagrama 18) 800-295-5510 uline.mx PAGE 8 OF 12 0321 IH-2083...

Este manual también es adecuado para:

H-1789