Delay Mode; General Notes - Rollei HS Freeze 4s Manual Del Usuario

Operation
32

Delay Mode

In this mode you can set a delay time . The flash will fire after this time is over . This
is used, for example, if you want to take a picture with some ambient light, but you
don't want to set the flash on the front nor the rear curtain . This might also be used
if you want to have motion in your picture but one single part of the image in the
middle of that motion should be sharp . Then you can set your camera's shutter time
and calculate the correct delay time that you can enter in the flash menu . Therefore
enter the delay mode and set the time between 00 .00 and a maximum of 30 .00
seconds .

General Notes

1 . FrFreeze Mode can only be used in manual (M . mode and it is focused on
providing the shortest possible flash duration at a given power setting .
2 . If the wireless remote control function is activated ((TTL-ALL / TTL-C / TTL-N /
TTL-S / TTL-F), the flash can only be controlled by the corresponding transmitter
that is available as an optional accessory .
3 . If the wireless remote control function U7 is activated, the flash can only be
controlled by the transmitter U7 which is available as an optional accessory .
Please note that this transmitter does not support High Speed Sync or TTL Mode .
4 . If the systems overheats, it will automatically go into an overheat protection
mode . The display will show „OH" which indicates that the overheat protection
mode is activated . In this event the system will stop responding while it recovers .
As soon as the temperature is back to an acceptable level, the flash will start
working again .
5 . If you start the continuous shooting mode in your camera, the flash power output
range is only available from 1 .0 to 3 .0 . Please note that the flash itself does not
have a continuous shooting mode and there will be no corresponding icon on the
flash display .
ENGLISH