DMX MODULE (GB)
DMX module features:
Standard DMX 512.A (ANSI 31.11-2008);
512 DMX addresses available;
3 addressing wheels for easy setting;
4 channels, RGBW;
120 Ohm resistor available;
TEST switching at 20%;
24 different shows pre-set;
data transmission speed 12 MHz;
16 bit resolution;
PWM frequency 600 Hz;
GREEN LED
Flashing green LED - 24V line working
Green LED off - 24V line not working
BLUE LED
Flashing blue LED, master mode active, transfer of DMX synchronization sygnal
Blue LED on, reception of DMX signal
Blue LED off, absence of DMX signal
RED LED
Red LED off - wiring of 24V fittings OK
Red LED off - wiring of 24V fittings not OK, 5 second protection mode
After 5 sec. the system checks the wiring, if still not OK the red LED remains on.
After 5 sec. the system checks the wiring, if still not OK the red LED remains on.
After 5 sec. the system checks the wiring, if still not OK the red LED remains on.
If after 3 attempts the problem persists the system blocks itself and the voltage must be cut off.
Identify the electric problem to re-set the processor and restore the correct functionality of DMX system.
12
Electrical specification:
Working voltage 24V;
Maximum input power 350W-24VDC;
Maximum input power per channel 80W-24V PWM;
Short-circuit protection;
Galvanic protection between primary and DMX;
Short-circuit test system on secondary;
S I M E S
