Beper P203PAN003 Manual De Instrucciones página 10

Wall mounted quartz heater Use instructions
Children aged from 3 years and less than 8 years shall only switch
on/off the appliance provided that it has been placed or installed in
its intended normal operating position and they have been given su-
pervision or instruction concerning use of the appliance in a safe way
and understand the hazards involved. Children aged from 3 years
and less than 8 years shall not plug in, regulate and clean the ap-
pliance or perform user maintenance.
Children of less than 3 years should be kept away unless continuously
supervised.
Joists, beams and rafters shall not be cut or notched to install the
appliance.
Do not install the appliance close to curtains and other combustible
materials. This could cause a fire.
Regulations concerning the discharge of air have to be fulfilled.
The appliance shall, under no circumstances, be covered with insula-
ting material or similar material.
The fireguard does not give full protection for young children and for
infirm persons.
The fireguard of this heater is intended to prevent direct access to
heating elements and must be in place when the heater is in use.
The heater must be installed at least 1,8m above the floor.
The heater must not be located immediately below a socket-outlet.
The heater needs to be installed so that the switches and other con-
trols cannot be touched by a person in the bath or shower.
Warning: this heater is not equipped with a device to control
the room temperature. Do not use this heater in small rooms
when they are occupied by persons not capable of leaving the
room on their own, unless constant supervision is provided.
Product description Fig. A
1. Heating mode indicator
2. Heating position switch
3. Heating lamps
Before the first use
When the device is turned on for the first time, a slight odor will occur. This is normal, ensure adequate ventila-
tion. This smell is only temporary and will disappear soon.
Wall mounting Fig. B
Determine a suitable location on a flat wall and keep at least 50 cm. free space from the top and the sides of
the appliance.
The heater must be installed at least 1,8m above the floor.
Following fig. B, drill four holes with a 6mm. drill bit. Place the 4 plugs and screws into the holes and insert the
heater over the screws.
10