Battery And Charger; Care And Maintenance - Nilox DOC ECO 3 Manual De Instrucciones

6. Battery and charger

6.1. Lithium battery
Fully charge the battery when you first use the Doc Eco 3
6.1.1. When the battery is running low recharge it immediately to avoid damaging it and
limiting autonomy.
6.1.2. If the scooter is not used for a long time, charge it at least once a month.
6.1.3. If the battery capacity is lower than the protection status and the scoter does not
work contact your dealer immediately.
6.2. Recharging
The battery charger supplied has a charging protection function. Power is automatically cut
off when the battery is 100% charged. Damage caused by water, collisions and other factors
are not covered by the warranty.
6.2.1. Open the rubber cover on the charging port on the lower part of the foot plate
of the scooter and insert the power input connector into the charging port.
6.2.2. Insert the charger input plug into the power outlet (AC100V-240V
6.2.3. . If the indicator on the charger is red the battery is charging; when it turns
green the battery is fully charged.
6.2.4. When charging the battery always place it in a dry and ventilated place.

7. Care and Maintenance

Lubrification: a small quantity of white grease or lubricant must be applied to the steering
column folding mechanism every three months.
Wheels: this product is fitted with solid wheels. If a wheel needs to be replaced due to
obvious wear or damage, please contact the service centre to replace it with an original one.
Always check the wheels are tightened.
Positioning and daily care:
Do not leave the scooter in the sun or in humid places for long periods; clean it with a dry or
damp cloth.
9
).