Safety Precautions; Assembly Procedure; Recommendations For Use; Cleaning And Maintenance - HURAKAN HKN-CS600H Manual Del Usuario

ATTENTION!
1. Prior to operation, make sure the juicer is installed on a flat horizontal surface.
2. It is prohibited to put fingers and foreign objects into the feed chute opening.
3. An uninterrupted operation cycle shall not exceed 10 minutes. After 10 minutes of
operation, the equipment shall be left turned off for 1 minute.

SAFETY PRECAUTIONS

1. Disconnect from the power supply, if not in use.
2. Cover may be removed only after the auger has completely stopped.
3. Prior to cleaning, make sure the equipment is disconnected from the power supply
mains. The bowl and the feed chute can be washed separately.
4. It is prohibited to immerse the motor unit into water, and to wash it in a dishwasher.
5. To avoid accidents, operate the equipment when children are away.
6. It is prohibited to use the equipment with damaged power cable, or when the equip-
ment was dropped or damaged.
7. It is prohibited to put metal objects, such as knives, forks, spoons, etc., inside the
equipment or to use them as pushers.

ASSEMBLY PROCEDURE

1. Install the bowl on the motor unit.
2. Fix the brush on the strainer so that it fits the niches.
3. Then, place the strainer into the bowl.
4. Insert the auger into the strainer and slightly press to fix it inside, so that is does not
obstruct the cover closing.
5. Place the cover on top of the feed chute and turn it clockwise.

RECOMMENDATIONS FOR USE

1. Do not forget to pit fruit (peaches, apricots, etc.). Fruit with pits may damage the
equipment.
2. Prior to loading the equipment, products with high fiber content, such as celery,
should be cut into pieces of 3-4 cm each.
3. Juice should be drank immediately after making for the best results.
4. The equipment is not recommended being used empty (without fruit etc.).

CLEANING AND MAINTENANCE

1. Prior to cleaning the equipment, make sure the power switch is in the OFF position
and the equipment is disconnected from the power supply mains.
2. The equipment case and cover shall be wiped with a soft towel or cloth.
3. Do not clean the internal parts before the auger is fully dismantled.
4. The motor unit shaft shall be cleaned with a dry cloth.
5. If necessary, use clean cloth with a small amount of detergent with medium pH level.
Never immerse the motor unit into water.
6. The feed chute, auger, filter and bowl shall be washed after every use. It is prohibited
to use abrasive agents and hard brushes for cleaning.
7. Make sure the equipment is properly cleaned prior to putting it into storage.
EN
9