Eldom cube KS200 Manual De Instrucciones página 17

CAUTION! Do not install the ice machine near an oven, heater or other heat sources.
- Before connecting the appliance to the mains supply, check that the mains current
parameters (voltage) comply with the parameters indicated on the appliance.
- If the appliance has not been used for a long time, before restarting it, check that the air
inlets and outlets are not clogged.
CAUTION! Only COLD DRINKING WATER without additives may be used in the ice
machine; spring water is recommended. For hygienic reasons, replace the water in
the tank every 24 hours. To avoid fungi and bacteria growth, leave the appliance's lid
open after use.
USE
- Make sure the appliance is disconnected from the mains supply.
Open the lid (5) and pour water into the tank (6). The water level should be between the
-
"MIN" and "MAX" indicators
CAUTION! The water must not come into contact with the ice container (10).
- Connect the appliance to the mains in compliance with the parameters indicated in the
manual - "B" indicator lamp on the control panel (3) will flash.
To turn the appliance on, press button "D" on the control panel (3). The "B" indicator
-
lamp on the control panel lights continuously.
- To turn the appliance off, press button "D" again.
CAUTION! If there is enough water in the tank (6) and during two cycles the appliance
will not pump it to the ice-making container (8) (the appliance will not start making
ice), move the appliance slightly forward. Then place a container underneath it, next
remove the silicone plug (11) at the bottom of the container (6) and allow some of the
water to drain.
CAUTION! For the first three cycles, ice cubes can be small and irregular.
No water
- when the indicator lamp "C" lights up and an audible signal can be heard
simultaneously,this means that the water level is too low for a full ice-making cycle.
- In this case, remove and empty the tank (10), then add water, put the container (10)
back and press button "D" to restart the appliance.
Emptying the ice container
- The appliance has a sensor (9) that indicates the ice container is full.
- When indicator "A" lights up, and an audible signal can be heard simultaneously, this
means that the ice storage container (10) is full.
- In this case, remove and empty the container (10), then put the container (10) back and
press button "D" to restart the unit.
17