Charging The Battery; Troubleshooting - Eldom hiit PI100 Manual De Instrucciones

Fig. 1
Do not use the following types of cookware (Fig. 1)
- with curved (convex / parabolic) bases
- with a base diameter of less than 12 cm
- with feet
- made of, among other things, clay, glass or aluminium
- is heavier than 5 kg.

CHARGING THE BATTERY

All the setting changes are confirmed with a sound signal.
The parameters set are visible on display "B".
The operation of the appliance can be stopped at any moment by pressing the "C" switch
(device switch off).
The appliance is equipped with a fan which runs all the time when the appliance is turned on,
and when switched off it runs until it has cooled down.
- Connect the appliance to a mains socket compliant with the parameters specified in the
manual - the appliance will switch into standby mode (4 flashing lines will appear in display
"B").
- Place suitable cookware in the centre of the cooking zone (see WHICH KIND OF COOKWARE
IS SUITABLE?).
- Press the "ON / OFF" "C" switch - the "E" indicator lights up and the fan starts.
- Press the "A" switch to select the programme:
- "SOUP" - the "D" indicator light lights up. The display shows the constant power level of
1200
- "HOT POT"- the "E" indicator light lights up. Use the knob to select power from 200 to
2000 There are eight power levels: 200/600/800/1000/1200/1600/1800/2000
- "FRY" - the "F" indicator light lights up. Use the knob to select the temperature, from 60
to 270. There are eight temperature levels: 60/80/100/180/200/220/240/270°C.

TROUBLESHOOTING

Before contacting the service department, please compare how the device operates under the
following circumstances.
ERROR
E0
E1
E2
E3
E4, E5, E6, E7, E8, E9
14 EN
X X
POSSIBLE CAUSE
No cookware in the cooking zone.
The wrong kind of pot is being used.
The voltage in the mains socket is too
low.
The voltage in the mains socket is too
high.
The cooktop surface temperature is
too high.
Problems with the appliance
>5
X X
SOLUTION
Place suitable cookware in the cooking zone.
Connect the appliance to mains with the
parameters specified in the manual.
Switch off the appliance.
If the error reappears, contact the service.
Switch off the appliance and contact the
service
<5
V