Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5.4. Imposition mode
During the creation of a time programming, it will command for the imposition mode. Each
imposition mode has its own particularities:
Forced mode
continuously to every system connected to the SuperMaster. Once the time program is
finished, an
or a
programs configured and the automatic mode activated).
Semi-forced mode
done, if on set-point temperature or on operation mode.
-
For set-point temperature programs an
hour. No check is done; it simply sets the temperature each hour.
-
For operation mode programs, it first asks for the operation mode in each system,
and if it is a non-allowed one, it swaps to the correct one.
Free mode
or the programmed set-point temperature
and a
or an
5.5. Configuring a program
*Note: At any moment while configuring you can go back to previous step by pressing
To configure a program (Fig. 15) do as follows:
1) From the main screen, press short on
2) Press short on the
3) Use selection arrows
temperature program (
press on the
set-point programming or
4) Use selection arrows
Confirm selection with a short press on icon
Note: If the day or group of days has already a program configured, icon(s) will stay still on any selection.
For example, if on Monday (1) there is already a program configured, on individual day selection, it will stay
still instead of blink. For other selections like week days of whole week it will blink.
: On this imposition mode the program will keep sending commands
will be sent to every zone if programming is for set-point temperature
will be sent if programming if for the operation mode (depending on the
: This imposition mode is different according to the program
: On this imposition mode, the operation mode will be set only once to
respectively at the end of the program.
icon to Access the programming menu.
to select the type of program you are to configure set-point
) or operation mode program (
icon. From this moment on, SuperMaster controller will display
for operation mode programming.
to select the day or group of days (they will be blinking).
+ (Temperature
on the starting time of the program
icon.
) and confirm with a short
.
or
) each
icon.
for
35
Tabla de contenido
