Safety Instructions - Berner BMM 1000 Manual De Instrucciones

Power supply
The machine shall only be connected to the voltage stated on the type plate
and it only works with single-phase AC voltage. It is provided with double
protective insulation according to European standards and thus, it may be
also connected to sockets without ground cable.
Do only use extension cables with sufficient cross section. A cross section
that is too small may lead to excessive loss of power and overheating of the
tool and the cable.

Safety Instructions

Read and observe these instructions before you use the machine.
ADDITIONAL SAFETY RULES FOR THIS MACHINE:
1. If the connecting cable is damaged or cut during work, do not touch it
and immediately disconnect the power plug. In any case, do not work
with the tool if the connecting cable is damaged.
2. The tool should not be humid and it should not be operated in a humid
environment.
3. Do not use the tool to mix explosive or easily inflammable substances
and do not use it in areas close to these substances.
4. Do not use the cable to carry the tool.
5. Do always inspect the tool, the cable and the plug before using it.
Repairs shall only be carried out by an expert. The plug shall only be
connected to the socket if the tool is switched off.
6. Do only operate the tool outdoor with a residual current circuit breaker
with a maximum of 30 mA.
7. Do not leave the hand-held mixer running unattended.
8. Do disconnect the power plug and check if the hand-held mixer is
switched off when it is left unattended, e.g. during assembly and
disassembly work, voltage drop, insertion and/or assembly of
accessories.
9. Do switch off the tool if it stops to operate due to whatever cause in
order to avoid a sudden start of operation when it is unattended.
10. Do always lead the cable away behind the tool.
11. Do not use the tool if a part of the housing and/or the switch, cable or
plug is damaged.
12. Power tools shall be inspected by an expert regularly.
13. Do not touch rotating parts.
14. Be careful with long hair. Do not wear loose clothing.
15. Do not manipulate the tool.
7