Berner BMM 1000 Manual De Instrucciones página 10

Warning!
Do only use the lock button if the tool is operated with the supporting stand.
If a standstill caused by the tool or a power failure occurs, do immediately
loosen the lock button by pressing the on/off switch in order to avoid the
unintended restart of the tool (risk of injury).
The mixer has an electronic switch in order to regulate the speed level by
keystrokes.
It is recommended to only use it when the machine is started or stopped in
order to avoid splashing material. If the continuous mode is operated with
reduced speed, it leads to overstress because the machine is not provided
with enough cooling air and overheating will occur significantly faster.
Care and Maintenance
Repairs shall only be carried out by qualified staff trained and experienced
in this area.
The tool shall be inspected by a skilled electrician after every repair.
The power tool is designed to require only a minimum of maintenance and
care. However, the following work shall be carried out and/or the following
parts shall be inspected regularly:
Do always keep the power tool and the ventilation slots clean.
•
Make sure that no foreign objects get into the power tool.
•
If the tool breaks down, the repair shall only be carried out by an
•
authorised shop.
Information on noise and vibration
Measured values determined according to EN 60745
The A-weighted noise level of the tool is typically:
Sound pressure level (L
Sound power level (L
Uncertainty K=3 dB.
Wear ear protection!
Hand-arm vibration:
Hand-arm vibration is typically lower than 1,6 m/s².
Measured values determined according to EN 60745
The vibration emission level indicated in these instructions has been
measured in accordance with a standardised test method given in EN
) 79 dB(A);
PA
) 90 dB(A)
WA
Uncertainty K 0,1 m/s²
9