Conceptronic C54PSERVU Guía De Instalación Rápida página 22

ENGLISH
7 Add the Print Server Port to your Client Computer
If you installed the Print Server on the Client Computer before you changed the IP
Address, the Print Server Port is not installed.
With the steps below you can add the Print Server Port manually, after you changed
the IP Address of the Print Server with the C54PSERVU Server Manager.
These steps are not necessary if the Print Server is found (See Chapter 6.2, step 5).
1. Click on "Start", "Programs", "Conceptronic", "C54PSERVU", "Network Driver",
"Network Ports Quick Setup".
2. The Network Ports Quick Setup will scan for available Print Servers, please wait.
When the scan is complete, you will see the following screen:
If the Print Server is not listed at the "Available Ports" list, you can click
"Refresh" to scan again for available Print Servers.
If the Print Server is still not found, check the following options:
- Is the Print Server connected to your network and turned on?
- Does the Print Server operate in the same IP Subnet mask as your network? (You
can change the IP Address with the Server Manager Utility).
- Ping the Print Server (Send a response package) with the following command:
• Open the command prompt. ("Start", "Programs", "Accessories", "Command
Prompt").
• Execute the command: PING [IP ADDRESS OF PRINTSERVER] and press Enter.
If you get a response, the Print Server is active in your network range.
2
22