Hardware Installation; Software Installation - Conceptronic C54PSERVU Guía De Instalación Rápida

ENGLISH

5. Hardware installation

Note: It is recommended to install the printer on your computer first. It is possible that
during the installation of your printer the setup wizard of the driver and software
installation will search for your printer. If the printer is not installed on your
computer it can give problems when installing and using the Print Server.
When your printer is installed, you can proceed with the steps below.
1. Make sure your printer is working normally on your computer before you proceed.
2. Power down the printer and disconnect the printer from the computer.
3. Connect the printer with the USB cable to your Conceptronic Wireless Print Server.
4. Make a connection between the Print Server and your network. (For example:
Connect the LAN cable to the Print Server and your Router or your Switch).
5. Power-on the Printer and connect the power supply to the Conceptronic Wireless
Print Server. The print server will perform the Power-On-Self-Test (POST) after it is
powered on. During the POST, the Status and Ready LEDs will be on. When the LEDs
are unlighted, the print server is ready.
Note: Your Conceptronic Wireless Print Server has a default IP address. This IP
address can be different than the IP Range of your network or it can give a
conflict with a device in your network with the same IP Address.
To prevent or solve this issue, you can use the C54PSERVU Server Manager
(see chapter 6.1 for installation) to change the IP address of the Print Server.
By default, the IP address of the Print Server is: 192.168.2.2

6. Software Installation

To make use of the Print Server and the attached printer, each computer needs the
Network Driver for the C54PSERVU. The Network Driver will enable the access to the
Print Server. For management of the Print Server, you also need the Server Manager
Utility. This chapter will explain how you can install the Network Driver & Server
Manager.
Insert the CD-ROM delivered with the Conceptronic Print Server in your CD-ROM
drive. The C54PSERVU Menu should appear automatically.
If the Menu does not appear, use Windows Explorer to navigate to the CD-ROM and
execute "Autorun.exe".
16