Tabla de contenido
Idiomas disponibles
Idiomas disponibles
19 Check for damaged parts
Before using the tool, carefully check it for
damage to ensure that it will operate properly
and perform its intended function. Check for
misalignment and seizure of moving parts,
breakage of parts and any other conditions
that may affect its operation. Have damaged
guards or other defective parts repaired or
replaced as instructed.
Do not use the tool if the switch is defective.
Have the switch replaced by an authorized
BTI repair agent.
20 Have your tool repaired by an
authorized BTI repair agent
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
Additional safety rules for cutters
•
Always use cutters with a shank diameter
corresponding to the size of the collet
installed in your tool.
•
Always use cutters suitable for a speed of
30.000 min
-1
and marked accordingly.
•
Never use cutters with a diameter exceeding
the maximum diameter indicated in the
technical data.
Package contents
The package contains:
1
Router
1
Parallel fence with fine adjustment and guide
rods
1
Collet 8 mm (GB: 1/4")
1
Guide bush 24 mm
1
Wrench # 17
1
Dust extraction plug
1
Instruction manual
1
Exploded drawing
•
Check for damage to the tool, parts or
accessories which may have occurred
during transport.
•
Take the time to thoroughly read and
understand this manual prior to operation.
29
Description (fig. A)
Your BTI high performance router BTI-OF 1100 E
has been designed for professional heavy duty
routing of wood, wood products and
plastics.
1
Lock-on/lock-off switch
2
Spindle lock
3
Collet nut
4
Parallel fence locking bolt
5
Guide rods for parallel fence
6
Dust extraction outlet in parallel fence
7
Fine adjuster for parallel fence
8
Parallel fence
9
Locking bolt
10 Router base
11 Finger guard
12 Revolver depth stop
13 Depth stop
14 Depth stop locking bolt
15 Plunge limiter
16 Quick adjuster for depth stop
17 Fine adjuster for depth stop
18 Dust extraction adaptor
19 Speed control dial
20 End lock
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power
supply corresponds to the voltage on the rating
plate.
Your BTI tool is double insulated in
accordance with EN 50144; therefore
no earth wire is required.
Mains plug replacement
(U.K. & Ireland only)
•
Should your mains plug need replacing and
you are competent to do this, proceed as
instructed below. If you are in doubt, contact
an authorized BTI repair agent or a qualified
electrician.
•
Disconnect the plug from the supply.
•
Cut off the plug and dispose of it safely; a
plug with bared copper conductors is
dangerous if engaged in a live socket outlet.
•
Only fit 13 Amperes BS1363A approved
plugs fitted with the correctly rated fuse (1).
E N G L I S H
en-3
Tabla de contenido
