Toparc 058248 Manual De Instrucciones página 5

Translation of the originals instructions
mm. Be careful, the air consumption of your tool must be higher than the minimum priming rate of your lubricator. A shut-off valve must be placed
upstream.
• The connection between this filter-regulator-lubricator assembly and the tool is done via an compressed air line made of rubber or PVC with a
maximum length of 10 metres and an internal diameter of at least 8 mm for tools with a 1/4» supply connection and 12 mm for 3/8» connections. It
must be equipped with an automatic or semi-automatic closing connection close to the tool, for easy disconnection.
APPLICATION
• Only use accessories in perfect condition that correspond to the characteristics of the tool.
• Avoid running the tool empty. If this is the case, after a long period of use, make sure that no accessories are attached to the tool. It is essential
to disconnect the tool for the installation of accessories. Check that they are perfectly fitted before connecting the tool.
• Regularly inspect the condition of the supply piping. In the event of damage or leaks, proceed to immediate repair. A broken pipe can cause
serious injury. Periodically check lubricator levels, filter and pipe purging.
MAINTENANCE
• At the beginning of the day and before a prolonged period of no use, pour a few drops of specialist oil directly into the hole. Do not use flam-
mable liquids such as gasoline and diesel.
• Regularly check the condition of the regulating filter and the oil level in the lubricator of the air system.
• Ensure that the supply connections, piping and accessories are in perfect condition. Regularly drain the compressor pipes and tank. Don't forget
your probation deadline.
• Only original parts available from the supplier may be used for tool maintenance.
• The company JBDC cannot be held responsible for changes made to the tools and non-compliance with general safety rules relating to the use of
compressed air.
Quick connection
0.5 m
TECHNICAL FEATURES
Ideal for sheet metal stripping work
- The abrasive holder is of the «Roloc» type.
Disc
Rotational
diameter
speed (t/min)
(mm)
50 & 75 15 000
SPEED CONTROL
The speed is adjusted on the back of the mini-grinder. Two speeds are available:
- Vertical button: fast
- Horizontal button: slow
CHANGE OF ABRASIVE
1. To replace the abrasive, hold the rotating support in place.
2. Unscrew the disc counter-clockwise to remove it and vice versa to screw it in.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
MINI GRINDING SET
10 m max.
Length Weight Noise level
(mm) (gr) (db)
100 600 85.6
Filter regulator
lubricator
Purge
Sound pressure Consumption
level dB (A) (L/min)
96.6
Slope
Valve
Compressor
Air pressure Power supply
(bars) connection
91 6.2
EN
1/4''
5 5