Lutron Electronics Energi Savr Node QS DALI Manual De Instrucciones página 3

English Español
Energi Savr Node
Step-by-step installation instructions
Step 1: Mounting the Energi Savr Node QS unit
Note: Mount the Energi Savr Node QS unit in a position where it
can be easily located and accessed if service or troubleshooting
is necessary. The Energi Savr Node QS unit should be mounted
with the directional arrows pointing upwards.
• For indoor use only!
• C hoose panel mounting location so mains voltage wiring is at
least 1,8 m from audio or electronic equipment and associated
wiring (prevents radio frequency interference).
• Install in accordance with all national and local electrical codes.
Use an IP20 (minimum) rated consumer panel or breaker
panel with integrated DIN rail and dead cover. The Energi
Savr Node QS unit is 161,7 mm (9 DIN modules) wide.
To clip the Energi Savr Node QS unit onto the DIN rail:
1. Hook the Energi Savr Node QS unit onto the top of the DIN rail.
2. Pivot the Energi Savr Node QS unit onto the DIN rail.
3. Press until the Energi Savr Node QS unit clips lock into place.
To remove the Energi Savr Node QS unit from the DIN rail:
1. Verify power to the unit is turned off.
2. Using a screwdriver, pull the orange clips until they click into the
unlocked position.
3. Reverse the steps above.
Energi Savr Node QS DALI Installation Guide
TM
English
Français Português
|
QS DALI Installation Guide
TM
Italiano Deutsch
1 1 2 2
QS
3 3 4 4
Energi Savr Node
Hi Temp
QSNE-2DAL-D
Test
230 V~ 50/60 Hz 100 mA
www.lutron.com
Power +44.(0)20.7680.4481
L N
0,5 N m
8 mm
Locked Unlocked
中文
Ethernet DALI 1 DALI 2
QS
TM
®
Z096
N1771
V
D E
Lutron 3
|
®