Fitting And Removing Blades; Setting The Pendulum Action - Rebel RB-1031 Manual Del Usuario

• It takes about 1,5 hour to fully charge the power tool.
• AC charger and battery may heat up during charging. It is a normal behavior.
• When power tool is not in use, it is recommended to charge the battery every three
months.
• When you notice that the power tool performance is decreasing, recharge the battery.

Fitting and removing blades

Notes:
• Switch off the jigsaw and remove the battery before changing the blade or carrying out
any other work on the jigsaw.
• Wear protective gloves to avoid any injury while handling the blade.
• Always clean out all chips or foreign matter adhering to the blade and/or blade holder.
Failure to do so may cause insufficient tightening of the blade, resulting in a serious
personal injury.
• Prior to assembly, place the power tool on the battery socket on a flat and stable surface.
• Use only T-type blades.
• Blade type depends on the material of the workpiece. Blades included in the set are
intended for cutting wood, plastic and metal.
Blade for cutting wood/ Blade for cutting plastic/ Blade for cutting metal
To fit the blade properly follow the below instructions:
• Open the anti-splinter guard (5).
• Pull the blade clamp lever up and hold it in this position.
• Slide the blade inside the blade holder until the stop with the teeth facing forwards.
Make sure the back of the blade is inside the roller guide.
• Release the lever. Make sure the blade has been securely mounted by pulling it out. It
is not possible to pull out the blade if it is mounted properly.
• Lower the guard.
WARNING! When removing a blade, be aware that it can be ejected by the spring load
force. Never position yourself facing to the blade. Always hold blade firmly during
insertion or removal.
To remove the blade follow the below instructions:
• Open the anti-splinter guard.
• Pull the blade clamp lever up and hold it in this position.
• Carefully slide out the blade.

Setting the pendulum action

The pendulum action consists of the blade stroking up and down and simultaneously
rocking in a pendulum-like motion i.e. the blade moves forwards and backwards.
The pendulum action switch can be set in four positions. The setting depends on the type
of the cut and the workpiece material.
EN 44