Scosche POWERUP 700 Manual De Instrucciones página 4

Tabla de contenido
.,
�//
JUMP STARTING VEHICLE
IMPORTANT: Before jump starting the vehicle, the battery level of the PBJ700 needs to be 75% or
more. Refer to battery level chart on page 3.
1. Connect jumper cables to the Powerbank (A).
2. Connect the RED clamp to the positive (+) battery tem,inal first (B), then connect the BLACK
clamp to the negative (-) battery terminal (C).
3. Before jump starting, check the jumpstart-ready indicator light located next to the "Boost" button.
Note: The Green indicator light on Powerbank indicates it is ready to jump start. DO NOT
PROCEED unless light is Green. Refer to chart below.
4. Start the vehicle (D). Note: Rest for 10 sec. between each starting attempt.
5. Once vehicle is started, remove jumper cables from battery starting with the BLACK clamp
first (El then the RED clamp (F). Finally, disconnect
the jumper cable from the Powerbank (G).
BOOST BUTTON
Note: A discharged car battery (Low Voltage) will trigger the
PBJ700's Low Voltage Protection.
Connect the RED Clamp to the positive (+) battery terminal
first, then connect the BLACK Clamp to the negative (-)
battery tem,inal. Note: Make sure polarities are not crossed
or clamps are not connected to same piece of metal.
Press and hold Boost button for 3 seconds.
Jump start ready indicator light will turn Green.
Once vehicle is jump started, remove jumper cables from
battery starting with the Black clamp first then the Red clamp.
JUMP STARTING WARNINGS
Do not touch the Red & Black clamps together or connect to the same piece of metal.
Do not use the jump start cable for any other purpose other than jump starting the vehicle.
Always confim, that jumper clamps are well connected and polarities are not crossed.
Keep clear of battery when jump starting the vehicle.
Use in well-ventilated area.
Make sure the vehicle's ignition is off before making cable connections.
' - ��
+
4
�;/I
LED JUMP START INDICATOR
Green
Ready to jump start
Jumper cable
Solid
connection not
Red
solid or incorrect
Blinking Jumper Starter has
Red
low battery
Low Voltage Protection.
No light
Refer to "Boost Button
Seclion"
Tabla de contenido
loading

Este manual también es adecuado para:

Pbj700

Tabla de contenido