Getting Started - Jays a-Six Manual Del Usuario

Getting started

EN
Power on/off and pairing
To power on, press and hold the center button for 3s. A voice assistant will tell
you the current battery status. Pairing mode will automatically be initiated,
indicated by the LED blinking slowly. Go to Bluetooth
and select "JAYS a-Six Wireless". The blinking LED will turn off upon a
successful connection followed by a short audio beep.
To power off, press and hold the center button for 3s.
Reconnecting and additional pairing
Next time you power on, the earphones will automatically try to reconnect to
the most recently used device. If not found, or if you manually disconnect
through your device, pairing mode will automatically be initiated again. To force
pairing mode, press center button for 5s from off state.
Battery status and charging
When on, press and hold the down-button 2s for voice assistant battery status.
Battery high: 70-100%
Battery medium: 30-70%
Battery low: 0-30%
When battery is below 3%, "Battery low" will be announced automatically.
Charge using a USB cable and connect it to any certified USB power output.
Charging is indicated by a solid red light, and a full charge is indicated by a solid
white light.
Troubleshooting
Problem pairing and connecting
• Make sure the earphones are not connected to another device.
• Disable and enable Bluetooth
• Move the earphones closer to the device or alter their positions to avoid
Bluetooth ® interference.
• Verify no other wireless equipment interfere with your earphones Bluetooth
signal.
Problem with sound transmission
Move the streaming device to another position. Your body, distance, different
materials and other wireless equipment can interfere with the wireless signal
between your device and earphone.
FAQ and quickstart guide
Visit jaysheadphones.com for more instructions and help on this product.
®
on your device.
settings on your device
®
®