BGS technic 70108 Manual Del Usuario página 4

SCHEMATIC ILLUSTRATION
A = Pulling bolt
B = Bearing
C = Body
1. Chose suitable puller bolt. The size has to be
chosen in accordance to the internal diameter of
the bearing to be pulled.
2. Insert the puller bolt through the inner ring of the
bearing so that the pulling edge of the bolt grabs
behind the bearing inner ring.
3. Adjust the diameter of the puller bolt to the
internal diameter of the bearing by tightening
the puller screw.
4.1 Using with sliding hammer
Mount slide hammer onto the adaptor screw and
pull out the bearing by operating the glide hammer
carefully.
4.2 Using with puller
Mount two-arm puller onto the adaptor screw and
pull out the bearing by twisting the two-arm puller.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Sliding Hammer
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
Puller
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed