Teeter Hang Ups Contour Serie Instrucciones De Ensamblaje página 14

FIGURE 19
FIGURE 20
20˚
40˚
60˚
90˚
Step 7
Attach the EZ-Angle™ Tether Strap (F5-1008) to Limit the Degree of Rotation
• The Tether will come pre-assembled to the A-Frame.
• Unfold the adjustable Tether and clip it to the U-Bar on the underside of the Table Bed
(Figure 19).
• The EZ-Angle™ Tether has color coded angles to assist in varied angles of inversion for your
experience level (Figure 20):
20° / Twenty Degrees – adjust the strap so the green stripe is in the center of the sliding
buckle for inversion to a gentle twenty-degree angle.
40° / Forty Degrees – adjust the strap so the orange stripe is in the center of the sliding
buckle for inversion to a moderate forty-degree angle.
60° / Sixty Degrees – adjust the strap so the red stripe is in the center of the sliding
buckle for inversion to a more advanced sixty-degree angle. This is the angle when full
decompression is realized.
90° / Ninety Degrees – Remove the tether strap clip from the base of the table bed loop to
enable rotation to full inversion.