Safety Precautions - Yeelight YLCG002 Manual De Usuario

EN
Material of lamp body: Aluminum alloy + ABS

Safety Precautions

1. Please ganrantee the voltage before use. Any improper
voltage may cause damages to the product and cause
safety hazard.
2. Please install and use the product far away from heat
sources, such as heating vents and conditioner vents,
and places not exposed to sunlight.
3. Sensor is not allowed to covered by other objects.
Please clean the lamp with a soft cotton cloth and
without any corrosive solvents.
4. This device is for indoor use only. Do not spray water on
it or soak it in water to avoid any safety hazard.
5. Do not use this product as a toy for child play.
6. Do not disassemble the product. the light-emitting
diode may cause damage to your eyes.
7. This device will generate heat during operation. Please
keep proper ventilation.
8. The light source contained in this luminaire shall only be
replaced by the manufacturer or this service agent or a
similar qualified person.
Class Ⅲ Luminaire
We QINGDAO YEELINK INFORMATION TECHNOLOGY CO.,
LTD., Hereby, declares that this equipment is in compliance
with the applicable Directives and European Norms, and
amendments.
WEEE Disposal and Recycling
All products bearing this symbol are waste electrical and
electronic equipment (WEEE as in directive 2012/19/EU)
which should not be mixed with unsorted household waste.
Instead, you should protect human health and the
environment by handing over your waste equipment to a
designated collection point for the recycling of waste
electrical and electronic equipment, appointed by the
government or local authorities. Correct disposal and
recycling will help prevent potential negative consequences
to the environment and human health. Please contact the
installer or local authorities for more information about the
location as well as terms and conditions of such collection
points.
Supplier's Declaration of Conformity (SDoC)
Equipment approved using SDoC is required to be tested,
however, it is not necessary to use an FCC-recognized
accredited testing laboratory. However, as minimum the
testing laboratory used is required to maintain a record of
the measurement facilities as specified in Section 2.948 and
a record of the measurements made as specified in Section
2.938
3