Tools And Materials Required - Kohler ANATOLE K-2099 Instrucciones De Instalación

TOOLS AND MATERIALS
REQUIRED
S
Level
S
Drill with assorted bits
S
Socket wrench with 8" extension
and assorted sockets
INSTALLATION
S
Rough-in the supplies and drain
piping and trap.
NOTE: The supply stop
cannot extend more than 5" (12.7cm)
from the finished wall when in the open
position.
S
Install sufficient backing behind the
finished wall to provide a secure
material for the anchoring devices.
S
Apply five self-adhesive gaskets
(provided) to the top edge of the
pedestal.
S
Mark the centerline on the floor.
S
Position the pedestal on the floor
centerline so the mounting hole is
approximately 7-1/4" (18.4cm) from
the finished wall.
S
Carefully set the lavatory on the
pedestal.
S
Move the pedestal as required to
ensure proper fit in the desired
location.
S
Level the lavatory. Add more
self-adhesive gaskets as needed
to level the lavatory.
NOTE: The lavatory
supported by the pedestal.
S
Check the lavatory placement.
S
Mark the center of each anchoring
hole on the wall, and mark the floor
through the hole in the pedestal
bottom.
S
Carefully remove the lavatory from
the pedestal. Then move the
pedestal from the area.
A
1011304-2-
S
Tape measure
S
Framing square
handles
Gasket
Top of Pedestal
Finished
Wall
Anchoring
Holes
must be
2
Kohler Co., Kohler, WI U.S.A.
Pedestal
Mark Floor
Here