General Features; General Installation - Astralpool LumiPlus DMX Guia De Inicio Rapido

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be
implemented for installation and start-up. Therefore, the installer as well as the user must read the instructions before
beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the OnDMX V2 Power Supply, follow the instructions provided below:
1. CHECK THE CONTENTS OF THE PACK:
The content of the box is:
• ONLED DMX Power Supply:
I0832DMXI52: with power supply incorporated
I0832DMXFEI52: with external power supply
• Installation and maintenance manual.
• External Power Supply (only for power supply code I0832DMXFEI52, it works to 24VDC).

2. GENERAL FEATURES:

This product is exclusively designed to be used with Mini projectors, Quadraleds and Halospots of DMX RGB LEDs by Ig-
nialight. The manufacturer is not liable for possible damage or defects if products other than Ignialight products are used.
If the Power Supply does not receive DMX signal, the projectors will remain off.
This is an electrical device corresponding to class II, it is supplied to 230V; 50Hz.

3. GENERAL INSTALLATION:

Make sure that when installing the DMX Power Supply it is protected of corrosives environments.
The Power Supply I0832DMXFEI52 is connected to 24VDC by means of terminals 14 and 15. It can support up to a
maximum of 400VA. This power supply will be able to control up to a maximum of 100 Mini projectors RGB DMX of 4W
or 18 Halospot projectors RGB DMX of 21W.
DMX IN/OUT
DMX LINE
- + - +
TERMINATION
+ - + - + - + - + - + -
OUTPUT FOR DMX PROJECTORS
The Power Supply I0832DMXI52 is connected directly to the electrical red of 230V-AC through the borne 29, 31 and
33. It can support up to a maximum of 60VA, so 9 Mini projectors RGB DMX or 2 Halospots RGB DMX.
Supply input (24 Vcc):
Input /Output 1 DMX:
Input /Output 2 DMX:
24V DC
Supply Input (230V ~AC):
Input/ Output 1 DMX:
Input/ Output 2 DMX:
In installations with long lengths of power lines, it is advisable to install
the Power Supplies as near of the projectors as possible (with a longer
230V-AC line).
+ g Connection 14
- g Connection 15
GND g Connection 20
– g Connection 21
+ g Connection 22
GND g Connection 23
– g Connection 24
+ g Connection 25
2
GND g Connection 29
N g Connection 31
L g Connection 33
GND g Connection 36
– g Connection 37
+ g Connection 38
GND g Connection 39
– g Connection 40