Assembly And Installation - CHIEF MSP-DCCUST1 Instrucciones De Instalación

MSP-DCCUST1

ASSEMBLY AND INSTALLATION

The MSP-DCCUST1 short throw projector mount is designed to
be mounted to solid concrete, hollow concrete block, 2" x 4"
wood studs 16" on center, or steel studs.
Assembling Wall Plate to Brackets
1. Attach wall plate (B) to two dual stud brackets (G) using four
5/16" lock nuts (HF). (See Figure 1)
(G)
1
(HF) x 4
Figure 1
Mounting Wall Plate and Brackets
NOTE:
Proceed to the Concrete or Concrete Block, Wood
Studs or Steel Studs section, as appropriate for
installation.
Concrete or Concrete Block
1. Determine mounting location on wall.
2. Using dual stud brackets (G) with attached wall plate (B) as
a template, mark four holes in brackets as mounting holes.
(See Figure 2)
3. Drill four 3/8" holes at marked locations in wall. (See Figure 2)
4. Install either four Fischer UX 10 x 60 anchors [Part number
077871] (not included) or four Hilti HUD-L 10x70 anchors
(not included) into drilled holes. (See Figure 2)
5. Install four Grade 2 or better 5/16 x 2-1/2" hex head lag
screws (not included) through four Grade 2 or better 5/16"
washers (not included), holes in stud brackets (G) and into
four Fischer or Hilti anchors (not included). (See Figure 2)
NOTE:
Proceed to Installing Short Throw Projector Arm to
Bracket section to continue installation.
6
(B)
2
x 4
3
(G)
x 4
5
Figure 2
Wood Studs
1. Determine mounting location on wall. Use a stud finder to
locate studs.
2. Using dual stud brackets (G) with attached wall plate (B) as
a template, mark four holes in brackets as mounting holes.
(See Figure 3)
3. Drill four 7/32" holes at marked locations in wall. (See
Figure 3)
4. Install four Grade 2 or better 5/16 x 2-1/2" hex head lag
screws (not included) through four Grade 2 or better 5/16"
washers (not included), holes in stud brackets (G) and into
four drilled holes. (See Figure 3)
(G)
4
x 4
2
x 4
3
Figure 3
Installation Instructions
4
x 4 Fischer or Hilti
anchors