Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. Position
the lower shoulder
strap clamp
under the u pper shaft and a lign the u pper
and lower clamp screw holes.
POWERHEAD
END
Strap Clamp
II
Lower Shoulder
•
Aqq-ACHMENT
Strap Clamp
|
_. END
!
Screws
4.
Insert two screws
into the screw
holes.
5.
Secure shoulder
strap clamp by tighten-
ing screws
with a hex wrench.
ADJUSTING
THE
ASSIST
HANDLE
_IIWARNING:
When adjusting
the as-
sist handle,
be sure it remains
between
the
coupler
and the _
lower arrow (closest
to
coupler)
on the safety label to ensure proper
balancing
of unit. When
adjusting
the assist
handle or handlebar
during use of optional at-
tachments,
it must be repositioned
between
the throttle
trigger and the
_
upper arrow
(closest
to engine) on the safety label.
1.
Loosen wing nut on handle.
2.
Rotate the handle on the shaft to an up-
right position;
retighten
wing nut.
ATTACHING
SHIELD
(FOR
LINE
TRIMMER
ATTACHMENT)
,_i, WARNING:
The shield mustbe prop-
erly
installed. The shield provides partial protec-
tion from the risk of thrown objects to the opera-
tor and others and is equipped with a line limiter
blade which
cuts excess
line to the proper
length. The line limiter blade (on underside
of
shield) is sharp and can cut you. For proper
orientation of shield, see KNOW YOUR TRIM-
MER illustration in OPERATION
section.
1.
Remove
wing nut from shield.
2.
Insert bracket
into slot as shown.
3.
Pivot shield until bolt passes through hole
in bracket.
4.
Securely
tighten wing nut onto bolt.
Slot
Shield
/
__iiii
Bra/cket
/
/
Une Limiter Blade
_
_
NWiu_g
KNOW YOUR PRUNER
READTHIS INSTRUCTION MANUAL AND SAFETY RULESBEFORE OPERATING YOUR UNIq:
Compare the illustrations with your unit to familiarize yourself with the location of the various controls
and adjustments.
Save this manual for future reference.
Pruner
Line Trimmer
Attachment
Bar
ON/OFF
SWITCH
Shaft
Shoulder
Strap Clamp
Attachment
Hanger
Starter
Handle ,_
Bar oil fill cap
Chain
Bar nut
The ON/OFF
switch
is located on the trigger
handle and is used to stop the engine. Move the
switch to the OFF position to stop the engine.
Switch
Fuel mix
fill cap
Primer
Bulb
Choke Lever
Muffler
PRIMER
BULB
The PRIMER BULB removes air from the car-
buretor and fuel lines and fills them with fuel.
This allows you to start the engine with fewer
pulls on the starter rope. Activate the primer bulb
by pressing it and allowing it to return to its origi-
nal form.
Tabla de contenido
