3.5 Installation Instructions
Attention! The appliance must be installed at level on solid surfaces. See pages 6-7 to
come up with
the most appropriate installation method for your ECONAT C-15.
1- Drill four 8 mm (5/16") diameter holes on the wall to the place where the unit will be
placed with the distances shown in Figure 1.
2- Insert the wall anchors supplied with the unit into the holes (Part #29).
3- With a star (Phillips) screwdriver, mount two of the L shaped legs on the wall using the
40 mm screws supplied with the unit (Part #18).
4- With the small (open end) wrench (Part #32), attach the other L-shaped bracket legs to
the heater as shown in Figure 2. Use the two 7.5 mm screws (Part #21). The female
threads are built into the heater housing.
5- Attach the heater brackets to the wall brackets using 8 mm bolts (Part #25), the 8 mm
cap nuts (Part #26), and the washers (Part #24) as shown in Figure 3. Tighten using the
large end (box end) of the supplied wrench.
6- You can adjust the unit's angle between a 0-45 degrees to achieve the optimal heating
effect (Figure 4).
7- Before operating the unit, recheck all the screws and bolts that they are tight. Be sure to
route the electrical cord so that it doesn't contact the heater housing.
11