Tabla de contenido
6159934880
Issue no : 03
Original instructions.
© COPYRIGHT 2014, DESOUTTER HP2
7SJ UK
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
STATEMENT OF USE
Product is designed for supply power to
Desoutter SLB tools.
No other use permitted.
For professional use only.
DATA
(See page 4).
REQUIREMENTS
This tool require an input voltage of 220/240VAC
or 110/120 VAC at 50/60 Hz; fused at 3 A.
WARNING
This power supply must be earthed.
OPERATING INSTRUCTIONS
● Switch off the power controller.
● Correctly connect the cable to controller and
screwdriver.
● Turn the controller on and select speed.
HI
LO
1
HI: (High speed) in this position the tool is
running at 100% of its rated speed.
2
LO: (Low speed) in this position the tool
is running at 70% of its rated speed.
Always use the correct Desoutter cable to
connect controller to the mains power supply. Do
not modify the cable or use it for other purposes.
Use only genuine Desoutter replacement parts.
Do not drop power supply or treat it roughly.
The power controller is not protected against
splashing water nor immersion, even temporary.
6 / 40
Should the power supply overheat abnormally,
interrupt the operation and send immediately the
unit to a service centre authorized by Desoutter
for repairs.
MAINTENANCE INSTRUCTIONS
● Only experienced and qualified personnel
● If in doubt, return to a Desoutter-authorized
● Inspect the mains cable for damage daily.
● Replace if damaged.
● When dismantling and assembling, follow
1
2
(authorized electricians) are entitled to open
and have access to the inside of the power
supply.
service centre (contact your local Desoutter
Sales for details).
normal engineering practices. Unsolder
only those wires necessary for component
removal. Always note colour code and
location of wires for correct assembly. Refer
to the illustration and build components into
subassemblies. On assembly, ensure earth
strap is properly secured.
When disposing of components,
lubricants, etc ... ensure that the
relevant safety procedures are carried
out.
12/2014
Tabla de contenido
