V2 JEDI-L Manual Del Usuario página 20

3. Self learning of the forces
-
3 3
PLEASE NOTE: On completion of the procedure, it is possible to exit the programming procedure, storing the parameters
set: press and hold the key for 5 seconds until the segments of the display illuminate one at a time until showing
4. Adjusting the sensitivity (default: 4)
This parameter is already set to a mid value (4) that should be ideal for the majority of installations.
-
4 4
4 4
5. Remote control button selection (default: 2)
-
5 5
3 3
0 0
PLEASE NOTE: if this parameter is modified, then on completion of programming, it is
necessary to conduct a complete open/close cycle, during which the control unit automatically
conducts a fresh force training operation (during this cycle, the motor works at maximum force,
so particular attention must be paid).
2 2
+ –
18
3 3
0 0
+ –
5 5