Remington MB-400 Manual De Instrucciones página 4

CS27742_MB-400_IB 8/31/05 4:36 PM Page 6
Operating Your Trimmer
Charging/Recharging
To recharge use only the charging adapter
provided.
Turn the trimmer OFF. Insert the adapter plug
into the jack, then plug the adapter into an
electrical outlet. The charging indicator will
glow green, indicating the unit is charging.
A full charge will take approx.14-16 hours.
Your trimmer cannot be overcharged. You
may leave it plugged in between uses.
However, if the trimmer is not going to be
used for an extended period (2 weeks),
unplug the unit and recharge when
resuming use.
Charge the trimmer at temperatures
between 40-90º F to avoid adversely
affecting battery life.
In order to preserve the life of the batteries,
they they should be charged for 24 hours.
Corded Rechargeable
Operation
The MB-400 is designed for cordless opera-
tion only. Plugging in the adapter cord will
not provide power to the trimmer, but will
only recharge the batteries.
Hair Length Selector and
Removable Trimmer Guard
Attachment
NOTE: Trimmer guard must be attached to
the trimmer in order to use the hair length
selector.
6
The hair length selector and trimmer guard
attachment ensures precise trimming and
has nine adjustable positions:
Setting Beard Style Length
1 Stubble look 1.5 mm - 0.06"
2 2.5 mm - 0.1"
3 Short 4 mm - 0.16"
4 5.5 mm - 0.22"
5 Medium 7 mm - 0.28"
6 9 mm - 0.35"
7 11 mm - 0.43"
8 Long 14 mm - 0.55"
9 18 mm - 0.71"
To adjust, roll the "Zoom Wheel" toward
the top of the trimmer to adjust for longer
length, and toward the bottom of the
trimmer for shorter length. The wheel
will click into one of nine positions.
Begin trimming at one of the longest
settings (#8 or #9) to avoid accidentally
trimming hair too short. As you become
familiar with the settings, you can then
select your desired length setting.
Trimmer Guard Attachment
Remove trimmer guard attachment if you are
defining hairline edges such as sideburns,
trimming the nape of your neck, trimming your
beard line on front of neck, or if you want to
clean the cutter assembly.
To remove:
Be sure the trimmer is in the OFF
position.
While holding trimmer in one hand and
holding the "Zoom Wheel" to prevent it
from turning, gently pull the trimmer
guard attachment away from the
trimmer. The guard
can be removed
and replaced on
any setting.
To replace:
Be certain trimmer is in OFF position.
While holding the trimmer in one hand,
and holding the "Zoom Wheel" to prevent
it from turning, slide the guard over the
top of the trimmer until it clicks into
position.
NOTE: The trimmer guard attachment can
only be placed on the trimmer one way; if it
does not fit properly, remove and reverse it.
7