Installation - Lehmannaudio Linear SE mk II Manual De Instrucciones

38 Linear SE

Installation

EN
In this chapter you'll learn more about the connections, controls
and possible applications of your Lehmannaudio Linear SE
headphone amplifier.
1 | Unpacking
After unpacking the Linear SE check it for possible transport damages. If you
notice visible damages, you must by no means connect the device to mains. In
this case consult your dealer immediately.
The delivery comprises the following components:
Linear SE unit
≠
Power cord
≠
User manual
≠
Guarantee voucher
≠
Note
We recommend keeping the entire packaging for later shipment.
That way you will avoid transport damages. Use by no means
'foam chips' or similar packaging material. Otherwise the device
will jolt through to the bottom of the cardboard box during
transport and can be damaged! If the original packaging is no
longer available, it's best to use bubble wrap in which to wrap up
the device in a generous manner. Finally the whole should be put
into a solid cardboard box.
2 | Placement
Always put the Linear SE on a solid base. Alternatively the device may also be
mounted under a table using the optional accessory kit. Due to its compact
dimensions and low weight you can take the Linear SE easily with you.
3 | Wiring
First check the present mains voltage since the Linear SE can only be operated
on the mains voltage which the unit has been designed for. This can be read on
a sticker on the bottom side of the device. Now connect the Linear SE to the
mains grid using the power cord and the mains inlet located on the rear side of
the unit.
Observe the safety notes from page 30!
Linear SE 39
EN