Connecting The Electrics - LUCTRA LINEAR TABLE Traducción Del Manual Original

TABLE PIN
▶ see image 5
You have following mounting options available for the TABLE PIN (11):
Mounting with a cable hole
The TABLE PIN holds your lamp firmly on any mounting hole ranging from 20 mm to 80 mm.
1. Attach the adhesive foam pad (13) to the upper plate (12).
2. Place the upper plate (12) with the pin and threaded rod (16) from above into the mounting
hole.
3. Screw the lower plate (14) facing upwards onto the threaded rod (16) using a centring
gauge matching the diameter of the mounting hole.
4. Run the power cable through the designated opening (15)
NOTICE!
Risk of damage to the cable!
Do not fasten the TABLE PIN by rotating the lower plate once you have run the power
cable through the designated opening (15).
Otherwise the cable will wrap around the threaded rod and be damaged.
5. Fasten the TABLE PIN by rotating the threaded rod (16). Use the enclosed Allen key to do
this.
6. Place the lamp onto the pin of the TABLE PIN (11).
Mounting without a cable hole
You can fasten your lamp to the TABLE PIN even if the table does not have a cable hole.
NOTICE!
Risk of property damage!
The table top must be at least 25 mm thick so that it is not damaged when adjusting
the lamp.
1. Drill a hole in the table top with a minimum diameter of 6.5 mm/maximum diameter of 8
mm.
2. Insert the pin with the threaded rod (16) and washer (17) through the hole from above.
3. Fasten the TABLE PIN by screwing the plate (14) facing upwards to the threaded rod using
the wider centring gauge.
4. Place the lamp onto the pin of the TABLE PIN (11).

Connecting the electrics

▶ see image 6
1. Connect the connecting cable of the lamp to the power supply unit.
Note:
You must first release the plug lock (18) to disconnect the lamp and power supply unit.
2. Fit the plug appropriate for your mains power network onto the power supply:
– European-style plug (19)
– British-style plug (20)
3. Plug the power supply into the socket.
EN
English
LUCTRA | 19