Seal And Install Wall Jambs; Install Side Panels - Kohler K-701611 Guia De Instalacion

Apply a Bead of
Silicone Sealant Full
Length of Wall Jamb
Wall
Jamb
No. 8-18 x 1-3/4I
Panhead Screw
Wall
Jamb

3. Seal and Install Wall Jambs

- Apply a bead of silicone sealant to the full length of the sealing groove on the back side of the wall jamb.
Slightly overfill the groove with sealant as shown.
- Position the wall jamb with the sealing groove toward the outside of the shower and align the holes in the wall.
- Secure the wall jamb with 3 #8 x 1 3/4" panhead screws.
- Repeat procedure for the other wall jamb.

4. Install Side Panels

- Carefully lift side panel and place the expander jamb side over the wall.
- From inside the shower insert a Phillips screwdriver tip through the adjustment holes (2), and turn the adjustment
blocks counterclockwise until blocks are firmly against wall frames insuring that the side panel rests firmly on
receptor ledge.
- After adjusting the side panel, install two #8 x 3 1/2" flathead screws into the adjustment holes of the expander
jamb and secure side panel in place.
- Repeat procedure for other side panel.
Kohler Co.
Sealing Groove
Toward Outside of
Shower
No. 8-18 x 3-1/2
Flathead Screw
Adjustment
Block
Wall
Jamb
Adjustment
Block Hole
Adjustment
Block
Shower
Receptor
5
Expander
Jamb Side
No. 8-18 x 3-1/2I
Flathead Screw
Column
Side
No. 8-18 x
3-1/2I
Flathead
Screw
Adjustment
Block Hole
A
1012601-2-