Assembling The Device; Transportation And Storage - MSW IR-DRYER3000.2 Manual De Instrucciones

IR-DRYER2000.2 | IR-DRYER1000
2
1
2
3
4
4
CONTROL PANEL DESCRIPTION
ON/OFF TIMER
OPERATING PRINCIPLE
1. Assemble the device in accordance with the diagram and position it correctly.
2. Then connect to power supply and turn on.
3. Use the knob to select the time foe which the device is to be active.
4. When not in use device off and disconnect it from the power source.

ASSEMBLING THE DEVICE

Assemble the device in accordance with the overview diagram below.
7
6
5
4
3
2
1
9
25
10
11
24
12
13
23
22
14
21
15
20
16
19
18
17
12
1
Device description
1. Emitters
2. Support post
3
3.
Bottom support frame
4. Wheels
ON/OFF switch
TIMER – Time settings
8
Rev. 26.11.2018
NUMBER DESCRIPTION
1 Vertical support post
2 Upper cap
3 Plastic trim
4 Left clamp
5 Support frame
6 Terminal strip
7 IR unit
8 Plastic lever for adjusting angles
9 Connector
10 Right clamp
11 Handle
12 Bottom support rod
13 Top support rod
REPLACING LAMPS
1. Dismantle the IR unit
3. Remove the housing from both
sides of the IR unit.
5. Then remove the bulb and install
a new one with similar parameters.

TRANSPORTATION AND STORAGE

During transport, the machine should be protected from shaking, crashing and turning upside down. Store it
in a properly ventilated place with dry air and without any corrosive gas.
Rev. 26.11.2018
NUMBER DESCRIPTION
14 Actuator
15 Actuator bracket
16 Front wheels
17 Support frame
18 Rear wheels
(with brake mechanism)
19 Flange
20 Cover
21 Control transformer
22 On/Off switch
23 Handle
24 Cover
25 Control panel
2. Remove the protective mesh
4. Remove the covers from both
sides of the IR unit.
6. Then assemble the IT unit and the device
in reverse order to dismantling.
13