HURAKAN HKN-BLW2 Manual De Instrucciones página 11

BEFORE FIRST START
1. Unpack the equipment, remove all the packaging materials.
2. Clean the equipment in accordance with the instructions presented in the "Maintenance and
care" section.
SWITCHING THE EQUIPMENT ON
1. The motor unit shall be installed on a stable support 800-900 mm in height with flat level
surface. The surface shall be dry and clean. The support shall withstand the equipment
weight.
2. Make sure that the power switch (on the left of the control panel) is in OFF position. Turn
on the power (put the male connector into the female socket).
3. Open the cover, put the ingredients into the glass and close the cover tightly.
In order to ensure free rotation of the blades, firstly, pour the liquid ingredients into
the glass, and then add the solid ones.
When processing solid ingredients (fruit, vegetables, meat, etc.), they must be pre-cut
into pieces of no more than 2 cm, and the glass can be filled with solid products for no
more than for a half.
When grating ice, it is necessary to fill the glass with at least 250 ml of water.
Otherwise, the ice will not be grated.
The glass should be filled considering the fact that when fluffing, the volume of the
mixture is getting bigger. The glass must not be overfilled.
It is not allowed to switch on the equipment with an empty glass.
4. Place the glass in its socket on the motor unit. Make sure that the glass is fixed in the
operating position.
ATTENTION! If the glass is installed incorrectly, the equipment cannot be switched
on.
5. Set the power switch to ON position.
6. Turn the speed controller to the desired position.
It is always recommended to start the blender at low speed to avoid spraying of liquid
or dry ingredients.
Speed adjustment can be made during operation without stopping the equipment.
7. To turn on the pulse mode, push the switch PULSE (on the right of the control panel). In
the upper position, the engine will rotate at maximum speed (26,000 cubes with an
interval of several seconds.
8. Hot products and liquids are recommended to be processed at low speed only. To avoid
burns, do not touch the glass or cover with your hands. Use protective gloves.
9. If you need to remove the contents from the walls of the glass and mix it, you must first
turn off the equipment. To perform this operation, it is recommended to use a plastic
scraper.
ATTENTION! To avoid overheating of the engine when processing solid products and
very thick mixtures, the continuous operation of the equipment should not exceed 2
minutes. Then the equipment should be cooled down for at least 2 minutes. In case of
overload, the fuse will automatically switch off the blender. In this case, it is necessary
to reduce the load and press the fuse button on the lower surface of the equipment,
after which you may continue the operation.
EQUIPMENT SHUT-DOWN
1. Set the power switch to OFF position.
EN
11