Controller Description - Genesis Irid 353 ARGB Instrucciones De Uso

USER MANUAL – ARGB FAN CONTROLLER
Attention – controller is pre-installed and ready to use right after connecting to power source.

Controller description

1. LED1 ... LED6 – ARGB backlight headers for fans. To get the right backlight e ect, connect the fans one by one. ARGB 3-PIN 5 V
type header.
2. SW – To the header can be plugged cable from the front panel of the case - "RESET" or "LED SW" (depends on the model) -
terminated with a 2-pin connector. By default cable is pre-installed. RESET/LED button on case allows then to change backlight
mode, turn mode o or switch to motherboard control of fans backlight.
3. DATA (or PC PWM DATA depends on the model) – header with pre-installed cable which ends with following connectors:
a) PWM – Connector can be plugged into designated 4-PIN PWM header on motherboard (it must be con rmed in motherboard
user manual, if 4-PIN header provides PWM signal or DC). It allows fan speed control from BIOS. If controller is not connected to
motherboard, fans run at default RPM. This PWM connector have 2 pins in fact, which is intended and correct.
b) ARGB – 3-PIN 5 V connector. After plugging into ARGB header on motherboard (check in motherboard user manual for header
location and speci cation), allows fan backlight control from BIOS / motherboard software.
Optional:
c) VDG – Gigabyte ARGB 3-pin backlight connector, only compatible with speci c manufacturer's motherboard models.
4. FAN1 ... FAN6 – 3-PIN fans power connectors.
5. LED7, LED8 - LED strip 3-PIN ARGB connectors.
6. POWER – SATA power connector.
EN
PL
DE
ES
CZ
SK
RO
HU
BG
RU