Beta 1498/12 Instrucciones página 5

ART. 1498/12 BATTERY BOOSTER
IMPORTANT NOTE : BEFORE OPERATING FOR THE FIRST TIME, CHARGE THE BATTERY BOOSTER WITH THE
SUPPLIED CHARGER FOR AT LEAST 12 HOURS.
1. Wear goggles whenever using the BATTERY BOOSTER.
2. Use of attachments not recommended or sold by the BATTERY BOOSTERs manufacturer, may result in a risk
of damage to the unit, or injury to personnel.
3. When using the charger or charging cable, pull on the plug and never on the wire when disconnecting.
4. Do not recharge the BATTERY BOOSTER with a damaged plug or cord. Replace the broken part immediately
(see point 2).
5. The BATTERY BOOSTER can be used under any weather condition (rain, snow, hot or cold weather).
6. Do not immerse in water.
7. Never bring the red and the black clamp into contact or allow them to contact the same piece of metal to avoid
short-circuits.
8. Do not operate near explosives and / or flammables such as gasoline, gas etc.
9. Do not try to repair the BATTERY BOOSTER yourself when defective, but always have it repaired by your distributor
(warranty will otherwise not be granted).
10. Never leave the BATTERY BOOSTER too long without recharging it. The severe damages caused by this may not
be not repairable..
IMPORTANT: When the engine starter is not in use, recharge it every 3 months with the supplied accessories.
However it is recommended to always keep it connected to the automatic charger.
1. Automatic charger with smart circuit which permits to leave the unit in charge continuously without damage.
2. 12V exit (cigar lighter socket), protected with an automatic reset breaker of 20A, to be connected to all sorts of
12V accessories or to charge the BATTERY BOOSTER.
3. Fully isolated clamps and copper cables (super flexible).
4. Surge protection.
1. To avoid short-circuits and to protect the clamps, which have a positive (=red) and negative (=black) current,
clamps must always be stored in the specially designed holders when not in use.
2. The cable holders on the case are to store the cables.
3. Thanks to its 12V sealed, non-spillable lead acid battery, the BATTERY BOOSTER may be used and stored in any
position and is state of the art technology.
1. Press the test button: if all 5 LEDs light up, your BATTERY BOOSTER is fully charged (the fifth led goes out when
you disconnect the unit from the charger).
1. With the supplied automatic charger, plugged in a 230V outlet (other voltages also available depending on
your country).
2. Once the vehicle is started, leave the clamps connected to the vehicle for 3 to 5 minutes so that the dynamo of your
vehicle can recharge the BATTERY BOOSTER.
12V appliance with automatic charger
When the BATTERY BOOSTER is not in use, always keep it connected to the supplied automatic charger!
1 - IMPORTANT SAFETY INSTRUCTIONS
2 - TECHNICAL SPECIFICATIONS
3 - SAFETY FEATURES
4 - CHARGE LEVEL
5 - HOW TO RECHARGE THE BATTERY BOOSTER
EN
5