Installing The Battery Pack - Orascoptic SPARK Serie Instrucciones De Uso

INSTRUCTIONS FOR USE
Spark Series Headlight
™

Installing the Battery Pack

The battery pack is held into place on the mounting clip by locking tabs on each side of the battery pack. Depress both locking
tabs when installing or removing the battery pack. The locking tabs will ' c lick' into place when the battery pack is secure.
Attaching the Spark Series
NOTE: Access to the mounting screw is located behind the LED headlight assembly. The assembly is designed to only rotate
down to be parallel to the battery pack and no further. DO NOT try force it down further than shown in the image below.
1. Swing the LED headlight downward to the 90° position as shown in the picture.
2. Using the screwdriver provided, loosen the mounting screw to allow the mounting clip to open enough to slip over the top
of your eyewear frame.
3. Center the Spark series on your frame and tighten the mounting screw until the unit is secure on the frame.
8