Epson SC-T7000 Serie Manual De Instrucciones página 2

Printing CAD Drawings
EN
CAD drawings can be printed by either of the following methods.
Using the Supplied Printer Driver
CAD/Line Drawing mode is recommended. For more information, see User's Guide.
HP-GL/2 or HP RTL Plotter Emulation
In the application, choose "HP 7600 Series Model 355"
device. Before printing, adjust settings in the printer control panel as described below.
* Not all functions are supported. Make test prints before printing from applications that have not
been tested. For a list of applications that have been tested, visit the Epson website at http://www.
epson.com.
1.
Select a paper type (Paper menu >
Select one of the following paper types. Choosing a type not listed below will result in
lower print quality.
Singleweight Matte/Plain Paper/Tracing Paper/Tracing Paper <Low Duty>
2.
Adjust HP-GL/2 settings (Setup menu >
Adjust the following print settings (default settings are indicated by
Quality
Output Size
Margin
* The smallest size supported by the printer is 254 mm (W) × 127 mm (L). For smaller sizes, trim
off the unwanted margins.
1
Item
Draft
Fine
A Series/US-ANSI/
Photo Series/etc.
User Defined
3 mm
5 mm
or its equivalent as the output
*
Select Paper Type).
Printer Setup > HP-GL/2 Settings).
Choose whether to give priority to print
speed or quality.
Choose from a list of supported standard
sizes.
When printing on paper not in the list of
standard sizes, choose this option and
enter the width and length in increments of
0.1 mm.
Width: SC-T7000 Series: 89
SC-T5000 Series: 89
SC-T3000 Series: 89
Length: 127–4620 mm
Choose the size of the top, bottom, left,
and right margins.
Description
–1118 mm
*
* –914 mm
–610 mm
*
).