Bestway 58628 Manual De Instrucciones página 5

BEFORE STARTING THE FILTRATION SYSTEM, YOU MUST BE SURE THAT ALL AIR
INSIDE THE HOSE OF THE CLEANER IS PURGED OUT. IF AIR REMAINS INSIDE THE
HOSE, THE FILTRATION SYSTEM WILL SUCK THE AIR AND IT WILL CAUSE SERIOUS
DAMAGE TO THE FILTER PUMP OR SAND FILTER. TO AVOID DAMAGE TO YOUR
FILTRATION SYSTEM FOLLOW THE BELOW PROCEDURES:
FILTER PUMP:
1. Connect the hose of the pool cleaner to the outlet of the pool following the steps above.
The pool cleaner must be inside the water and the hose connected correctly to the pool.
2. Start the filter pump for 30 seconds.
3. Stop the filter pump and open the purge valve of the filter pump in order to remove the air
collected. When water flows out, close the purge valve.
4. Start the filter pump for other 30 seconds.
5. Stop the filter and purge the air trap inside the filter pump following the operations in point 3.
6. Repeat the operation until the purge valve can be opened, and no air comes out.
SAND FILTER:
1. Connect the hose of the pool cleaner to the outlet of the pool following the steps above.
The pool cleaner must be inside the water and the hose connected correctly to the pool.
2. Start the sand filter for 30 seconds.
3. Stop the sand filter and unscrew the transparent cover of the debris screen until the air
flows out.
4. Start the sand filter for other 30 seconds.
5. Stop the sand filter and purge the air trap inside following the operations in point 3.
6. Repeat the operation until when you can stop the sand filter debris screen with the
transparent cap remaining full of water.
IMPORTANT: After setting up the pool cleaner, the product may not stop correctly. This
could be due to different situations, such as the ground not being flat, the hose getting
tangled, or many other things. In this case, you may have to manually move the item.
IMPORTANT: If the bottom of the pool is dirty, the net inside the pool cleaner, the filter
cartridge or the sand may have to be washed often. If the net, filter cartridge or the sand is
dirty, the pool cleaner will stop working. Remember to purge the air after cleaning the net
inside the pool cleaner.
HOSE WEIGHT APPLICATION
Ideally, the bottom surface of the cleaner should rest flat on the pool bottom. First, assemble the hose weight on the first long white hose (A) from
the cleaner. If the cleaner leans forward, move the hose weight along the long white hose towards the cleaner. If the cleaner leans backward, move
the hose weight to the next long white hose.
303021238513_58628_14x21cm 水力驱动清洁器说明书_英
5