Elnur Gabarron ECOMBI SOLAR Serie Instrucciones De Uso página 26

4.- REMOTE OPERATION USING THE G-CONTROL HUB
It is possible to control the full operation of the unit remotely with the Elnur Gabarron Wifi Control app or the app-web
(https://remotecontrol.elnur.es). The unit must be connected to a G-Control Hub connected to the internet to use this feature.
To associate the ECOMBI SOLAR unit to the G-Control Hub, follow the instructions of the installation wizard of the app.
- Open the application and login with your user and password.
- Access the heating menu in the top menu in the app.
- Press the button (+) and select the type of heater that you are going to connect (Storage heater).
- Press Start Search and follow the instructions of the installation wizard.
When required, keep pressed
You can control now and adjust the settings of your storage heater using the Elnur Gabarron Wifi Control app or the app-web
https://remotecontrol.elnur.es.
5.- TROUBLESHOOTING
ECOMBI SOLAR does not
heat.
ECOMBI SOLAR does not
reach set up temperature
Error messages in display
ECOMBI SOLAR does not
communicate with the G
Control Hub.
button during 3 seconds until the symbol
Please check it is connected and switched on.
Make sure the device is not covered or the lower air inlets are not obstructed. The LR safety limit
may be activated; in this case it is necessary to reset it manually. Please contact technician.
Make sure that adequate temperature is selected.
Make sure the storage heater is sized correctly for heat loss.
Please contact technician.
Check the unit is associated, the symbol
For distances greater than 30 metros and 2-3 walls, associate first the closest units. Each unit can
work as signal extender.
If symbol is flashing, check the G Control Hub connexion to the network, and if any other device
in the RF Net that could be working as signal extender has been removed.
is displayed in the storage heater display.
must be shown on the display.
25