Insert Batteries; Operating The Unit - TREVIDEA Ferrari G30028 Manual Del Usuario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

-
Place the food inside a containers and not directly on the scale. Gently put the containers on the scale.
Failure to comply with these instructions may invalidate the warranty in case of damages.
-
After finishing weight operation, empty the scale.
-
The buttons should be pushed gently and only with fingers.
-
If the display does not light up, it could be a battery problem: check that they are correctly installed and
they are not exhausted.
-
Not suitable for commercial use. Household use only
-
Do not immerse in water or other liquids and avoid splashing of water; clean it with a damp cloth only.
-
Do not subject the product to strong impacts, serious damage may result.
-
Do not use as a shelf for supporting objects.

INSERT BATTERIES

The compartment for the battery is located under the scale.
The scale works with 1 x CR2032 lithium battery.
- Open the door by pulling the lock tab. Remove any battery by gently pulling on the metal tab on the edge
of your battery. Insert the battery with the plus sign (+) facing up.
- To insert, push the battery into its slot until it stops. Close the cover.
CAUTION
- Always use lithium batteries CR2032 type. Do not heat, disassemble or throw in fire.
- Be sure to insert the battery according to the correct polarity as otherwise they may leak and damage the
scale. Such damage is not covered by warranty.
- When you are going not to use the unit for long time, it is advisable to remove the battery to prevent the
run-out.
- Batteries are collected separately. Dispose of exhausted batteries correctly, as required by national
regulation. Qualunque sia il tipo di batteria esaurita, essa non deve essere gettata tra i rifiuti domestici,nel
fuoco o nell'acqua. Ogni tipo di batteria esaurita deve essere riciclata oppure smaltita presso gli appositi
centri raccolta dedicati.

OPERATING THE UNIT

Before use, select the correct measuring unit by using the appropriate button on the base of the scale.
Weighing
-
Place the scale on the floor, avoiding carpets or soft surfaces.
-
Step on the scale and stand still for a few moments until the value flashes in the display.
-
Step off the scale. The weight will stay on for a few seconds, then the scale will turn off.
Select the measurement unit
Using the key in the base, the unit of measurement can be changed from kilograms (kg) to pounds (lb) or to
Stone (st) and vice versa. The display shows "kg" or "lb" or "st", depending on the unit chosen.
Exceeding load
The capacity of the scale is up to 150 Kg (330lb). Once exceeding that value, the display shows
Do not overload the scale, since this may cause serious damage. Pay attention not exceeding the maximum
capacity (150 Kg).
Low battery indication
When the battery is running low, the display shows
Replace the battery with a new one, following the steps shown in the "Insert batteries" section.
SWITCH-OFF
the scale is switched off automatically.
CLEANING -
Clean the unit with a damp cloth and soft and non-abrasive cleaners only.
The switch-off is automatic: once the weighing value is displayed, after a few seconds
.
.
4
Tabla de contenido
loading

Tabla de contenido