Tabla de contenido
Idiomas disponibles
Idiomas disponibles
introduction
The 3sixti
highchair is designed for maximum usability with various seat heights and six
2
different seat orientations.
1
parts list
1. inner tray
2. tray
3. backrest
4. seat
2
attaching the seat to the vertical leg
Turn the seat over and place the vertical leg (5) onto the on the seat (4) as shown.
Ensure the chair is aligned as in the illustration for correct assembly.
Secure the seat with 5 x M6 bolts (9) with a cross point screw driver (not included).
Note: Periodically check the bolts and retighten if required.
3
attaching vertical leg to the base
Align the arrows on the rear of the vertical leg and base (6). Push vertical leg into the hole
of base. Ensure the slot and buckle are aligned before inserting.
You will hear a "click" when they are secured into place.
4
attaching backrest
1. Insert the backrest (3) into the seat. Ensure the recline bar is properly inserted in the hole as
shown in the diagram.
2. Ensure the hooks securely locks to the seat.
3. Insert the seat fixing bar (10) into the backrest securely through the side of seat as shown in
the diagram.
5
attaching the seat cover
Place seat cover (7) over the seat and pull down into position.
Place seat cover over the crotch post as shown.
6
attaching and using the harness
A five point harness is provided to restrain your child. To fasten the harness push clips into
buckle. To unfasten push clips in and remove from buckle.
Sliding adjusters are fitted on the waist strap and should be carefully adjusted so the harness
fits your child comfortably. To adjust to the smallest size you will need to thread the adjusters
through the "D" ring.
'D' rings are fitted at the end of each waist strap should you wish to attach a separate harness
complying to BS EN 13210. The length of each strap can be changed by using adjusters (a), (b)
& (c).
WARNING: Always use the crotch strap in combination with the waist
strap.
7
attaching the inner tray
The inner tray (1) can be insert or removed by the clip (a) at the rear of the tray (2).
5. vertical leg
6. base
7. seat cover
8. harness
9. M6 bolt x 5
10. seat fixing bar
Tabla de contenido
