X-lander X-PULSE Manual Del Usuario página 9

1 U N F O L D I N G T H E F R A M E
Unclip the linking interlock (a). Unfold the pram by lifting its handle up until the locks (b)
are engaged. WARNING:
gears have been locked.
2 F O L D I N G T H E F R A M E
Detach the carrycot, seat unit or car seat from the frame. Pull the grips on the handle up-
wards (a). Fold the frame holding the handle as shown in the picture (b).
3 A S S E M B LY A N D D I S A S S E M B LY O F R E A R W H E E L S
To attach the wheel, press the button in the centre of the wheel and slide the wheel axle
into the mounting socket. Pull on the wheel to check that it is securely attached. In order
to remove the wheel press the button in the centre of the wheel and pull it out of the
mounting socket.
4 M O U N T I N G O F T H E F R O N T W H E E L
In order to mount the wheel, slide it onto the axle until the lock is engaged.
5
D I S M O U N T I N G O F F R O N T W H E E L
In order to take the wheel off, push the button shown on the figure, and pull the wheel off
the axis.
6 W H E E L B LO C K A D E
The stroller is provided with swiveling front wheels. A special button blocks the wheel
swiveling movement. After the button has been pressed, the wheels are blocked straight.
To release the blockade, press the lever.
7 H A N D L E L E N G T H R E G U L AT I O N
Press the button in the middle of the handle and adjust its height by pulling it towards you
to lengthen it or pushing it away from you to shorten it.
of the handle height should not be made when the stroller is in motion. Otherwise, you
may lose control of the stroller and damage the handle. It may threaten child safety.
8 B R A K E
To lock the wheels, press the brake lever in its closer part (a). To release the brake, press
the brake lever in its distant part (b).
9
S H O P P I N G B A S K E T I N S TA L L AT I O N
Fasten the snap fasteners and attach the basket to the chassis as shown in the pictures.
10 I N S TA L L I N G S E AT U N I T O N T H E F R A M E
Slide the catches of the stroller seat unit into mounting seats in the frame, until locks are
engaged. The seat unit can be mounted facing front or rear.
11
D I S M O U N T I N G S E AT U N I T F R O M T H E F R A M E
Push the buttons unlocking catches of seat unit in (a), then pull it out from mounting seats (b).
12 M O U N T I N G / R E M OV I N G T H E S T R O L L E R H O O D
To mount the basket to the frame, press the plastic basket holders onto the mounting pins,
then wrap the straps around the frame tube and fasten the snap fasteners together.
13 B AC K R E S T A D J U S T M E N T
Pick up the tie and put up the backrest in required position.
14
F O OT R E S T A D J U S T M E N T
Press the buttons on both sides of footrest and adjust it to the required position.
15
I N C R E A S I N G T H E H O O D I N C L I N AT I O N A N G L E
The hood may be expanded by an additional part. In order to do this, undo the zipper
between the upper and lower part of the hood.
Prior to assembling the baby carriage make sure that folding
WARNING: Changes in the position
7