Transport And Unpacking; Requirements For Installation Location - Panasonic PAW-TD23B6E5 Manual De Instrucciones

3.3.2 Pipe connections and valves
Ref. Dim. Description
a ø22 Radiator circuit return
b ø22 Domestic cold water in
c ø22 Domestic hot water out
d
3/4" Temperature and pressure valve (T&P)
e ø22 Radiator circuit flow
f ø22 Heat pump circuit flow
g 1/8" Air vent valve for heating system
h ø22 Heat pump circuit return
i DN15 Drain valves (DHW tank & buffer tank)

3.3.3 Transport and unpacking

The product should be transported carefully,
with packaging. Also please note:
• The product is very heavy and should not
be lifted by one person alone.
• Do not transport the unit horizontal. This
can cause damage or failure.
• To avoid hand injury, wear gloves when
moving the product and/or while remov-
ing the packaging.
• Be careful not to damage the product
while removing the packaging.
• To avoid damage an installed tank must
be drained before moving.
!
Pipe stubs, valves etc. should not be used to
lift the product as this could cause malfunc-
tions.
3.4 Requirements for installation, location
and positioning
The product shall be placed in a room with a drain to avoid any damages in case of water
!
escaping from the product.
The product must be placed in an area that is dry, clean, free of vapour, volatile oils,
!
smoke and gases to avoid any damages to internal parts of the product.
!
The product shall be placed in a dry and permanently frost-free position.
The product shall be placed on a floor surface suitable for the total weight of the product
!
when in operation. See product data plate.
Install the tank unit as close to the heat pump as possible. This limits the necessary vol-
!
ume of coolant (due to pipe length).
!
The product must have a service clearance of 120 cm in front of the cover / 50 cm on top.
!
The product shall be easily accessible in the home for servicing and maintenance.
CAUTION
a
b
c
d
e
f
g
h
i
! CAUTION
7