Silverline 834832 Manual De Instrucciones página 11

834832
Using the detergent dispenser
1 . When changing accessories, switch OFF the pressure washer, turn OFF the water supply and
squeeze the trigger to release pressure (Image A)
2. Remove the Nozzle (8) if fitted
3. Fit the Lance Detergent Dispenser (22) to the Lance Extension Socket (10)
4. Remove the dispenser bottle and fill with suitable pressure washer detergent or car shampoo,
then re-fit (Fig. V)
5. Use the pressure washer as per normal operation to dispense foam as required. The Trigger (16)
will control how much foam is dispensed . There are no adjustments on the detergent dispenser
6 . Use all detergent, ensuring water runs clear and is foam-free at end of use
Notes:
• A typical pattern of use for using detergent foam would be to first clean the surface with water to
remove light surface deposits, then apply detergent foam and finally, rinse off with clean water
• Detergent foam requires a few minutes to work when applied. For maximum cleaning, leave 2-5
minutes between applying the foam and removing with clean water - this is an ideal opportunity
to brush/scrub the surface where most dirt has collected . Do not allow foam to dry on the surface,
for instance, on a hot day, when there may be limited time between dispensing foam and rinsing
off, depending on the surface
• Do not use detergents which are not designed for use with pressure washers . They may contain
chemicals that could damage seals
• The detergent dispenser is only suitable for detergents with a viscosity close to that of water .
If necessary, dilute detergent before filling the detergent dispenser. This pressure washer
has an approximate detergent ratio of 1/19th or 95% water to 5% detergent in use . Read the
instructions provided with the detergent thoroughly - especially if concentrated . Diluting to
the detergent manufacturer's recommendations will ensure effective cleaning without using
excessive detergent
Switching OFF
When you have finished using the machine, always carry out the following steps:
1. Switch OFF the machine and disconnect from the mains supply (Image A)
2 . Turn OFF the water supply
3. Squeeze the trigger and allow all residual water pressure to bleed
4 . Disconnect the water supply
5 . Drain all water from the machine and hoses, and store in a dry place
WARNING: Do not switch OFF the water supply before turning OFF the pump as the pump must
not be run without water .
Accessories
A range of accessories is available from your Silverline stockist to enhance the functionality of your
pressure washer, including brushes and replacement, or higher specification parts.
Maintenance
Cleaning
• Keep your machine clean at all times
• Always allow all water to drain from the pump before storing
• The Nozzle (8) Lance Detergent Dispenser (22) and Lance Extension (10) may get dirty or blocked
over time, which will effect operation . Clean using the Cleaning Pin (20) supplied (Image B) .
• The Cleaning Pin (20) can be stored in the Cleaning Pin Bracket (23)
• A garden hose can also be used to clean the Lance components by back-flushing water through.
Combining use of the pin and back-flushing should allow the components to be thoroughly
cleaned. The frequency of carrying out this task will depend on the water quality in your area.
Hard water areas require more frequent cleaning
• Regularly check the Inlet Hose Connector filter to make sure it is clear. This filter must be checked
regularly to ensure it is clear from debris and other materials . Remove the Inlet Hose Connector
(21) to access the filter
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking
• If you suspect that the brushes may be worn, have them replaced at an authorised Silverline
service centre
Storage
• Always store this machine in a dry place that will not fall below 0˚C
• Ensure all inlets / outlets are capped if not connected to prevent foreign objects entering the
appliance when not in use
1400W Pressure Washer
Disposal
Always adhere to national regulations when disposing of appliances that are no longer functional
and are not viable for repair .
• Do not dispose of appliances, or other waste electrical and electronic equipment (WEEE), with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
appliances
silverlinetools.com
11