GYS BATIUM 25/24 Manual Del Usuario página 13

Translation of the original instructions
The displays shows
and flashes.
7
The display shows
for more than 1 min
and the indicator
8
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
BATIUM 25/24
The battery is in short-circuit or
damaged.
A power consumer has been left
on accidentaly during the charge.
(e.g : lights).
The charger is used as a power
supply to compensate for the use
of power consumers that are drag-
ging the battery's energy.
The charging speed is not adapted
to the battery.
CHE = check
The voltage is still too low to start
is on.
a normal charge.
The charger will attempt to recover
the battery for 30 minutes max,
then will resume a normal charge.
If the battery cannot be recovered,
the Barium will stop the charge
and display « OUT ».
Change the battery.
Switch off the power consumer
and continue/restart the charge.
Charger behaves normally but
incorrect use. The indicator that
signals the end of the charge can-
not switch on.
Select a higher charging speed .If
you're already set at 25 A, use a
more powerful charger.
Check all electrical consumers are
switched off on the vehicle (e.g.
lights, interior light).
Check that the selected voltage
matches the battery voltage. If
that's not the case, disconnect the
charger's clamps and reconfigure
the charger.
The battery voltage is abnormally
low, the battery is damaged or in
short-circuit.
EN
13