Intended Use; Before Use - Sonic 3T Manual De Instrucciones

Intended use

Jack stands are designed to support rated capac-
ity, partial vehicle loads consisting of one end of a
vehicle. Use both stands for each operation.

Before use

1. Inspect stands before each use. Do not use if
there are bent, broken or cracked components
(including labels).
2. Ensure that all parts move freely.
3. Read the operator's manual completely and
familiarize yourself thoroughly with the
product and the hazards associated with its
improper use before using this product.
4. Install ratchet bar into base frame with ratch-
et portion of bar aligned with locking pawl.
5. Move the ratchet bar to its lowest position by
raising the locking handle and guiding the bar
downward.
6. Insert cotter pin into the bottom hole of the
ratchet bar to prevent inadvertent loss of the
ratchet bar.
7. Always refer to the vehicle owners or service
manual for location of proper lift and support
points.
Operation
1. Adjust height by pulling up on ratchet bar.
2. Push down on the locking handle. The weight
of the locking handle should secure the
ratchet bar in desired position. Ensure ratchet
is secure before loading.
3. Carefully position stands so that load is
centered on stand's saddle.
4. Slowly lower the vehicle onto the stands.
5. Ensure vehicle is secure before working on,
around or under. When used to support vehi-
cle, use wheel chocks to prevent inadvertent
movement.
Note: Jack stands are not to be used to simul-
taneously support both ends or one side of a
vehicle. No alterations shall be made to this
device. Do not use adapters or accessories
on the saddle or base frame. No replacement
parts are available for this device. Replace as
a matched pair only.
To lower load
1. Raise vehicle clear of stands with suitable
jack.
2. Raise the locking handle to release stopper
and allow ratchet to glide down to lowest
position.
3. Carefully remove stands.
4. Carefully lower vehicle with jack.
5. Ensure that all tools, equipment and personnel
are clear before lowering load.
Maintenance
Maintain your jack stands
It is recommended that the general condition
of any jack stands be examined before they are
used. Keep your jack stands in good repair by
adopting a program of conscientious repair and
maintenance. Have necessary repairs made by
qualified service personnel.
Periodically inspect each stand
Ensure all parts move freely. Do not apply oil
or grease to any portion of this product. If rust
appears, sand affected area and cover with
suitable utility paint. Please note that there are
no replacement parts applicable to this device.
Storage
Store stands in upright position and in a clean,
dry area.
S O N I C - E Q U I P M E N T . C O M
|